Take control of your point cloud in CreativeTrack Alignment. Work with complete LiDAR actors or select individual regions, then isolate, clean up or extract the data you need.
Select actors or points
| Tool | Selects |
|---|---|
| Object | Whole point cloud actors. |
| Marquee | Points inside a rectangle. |
| Polygon | Points inside a polygon you define. |
| Lasso | Points inside a freeform outline. |
| Paint | Points in the area you paint. |
Each tool activates its matching LiDAR selection mode. Check Selected Points, Components and Actors before applying an operation.
Clear or invert a selection
Clear Selection clears selected points and point cloud actors. Invert follows the active tool: Object mode inverts actors, while point-selection modes invert points.
For floor work, Clear Points clears the selected floor points but retains the saved floor reference. See floor alignment for using that reference.
Isolate an area without deleting it
| Command | Action | Requires |
|---|---|---|
| Hide Selected | Hide the selected points. | A point selection. |
| Crop To Selection | Hide points outside the selection. | A point selection. |
| Reset Visibility | Show hidden points again. | Point-cloud actors in the level. |
For a clearer view, select a region and use Crop To Selection. Restore the cloud later with Reset Visibility. These commands change visibility, not the underlying point data.
Remove unwanted point data
Delete Selected permanently removes selected points. Delete Hidden permanently removes currently hidden points. Unlike the visibility tools, these commands change the point data.
Check selection and visibility first, and keep a copy of anything you may need. Use hiding or cropping for temporary isolation. Reset Visibility cannot recover deleted points.
If a command is unavailable
- Hide Selected, Crop To Selection and Delete Selected need selected points.
- Clear Selection needs selected points or actors.
- Invert, Reset Visibility and Delete Hidden need point cloud actors.
Select a LiDAR actor with Object, or use a point-selection tool for part of the cloud. Selecting an unrelated scene object does not provide point cloud data.
To create a separate asset, use Extract as Copy or Extract Selection. For geometry and collision, see point cloud mesh and collision.
